FreeToolNet

Terms of use

Last updated: 14 November 2026

Using the content

Posts are provided for general information. They describe what worked in a specific environment at a specific time, stated in each post. Software changes, and a command that was correct when published may not be correct later.

Test anything from this site in a safe environment before using it on a system you care about. You are responsible for what you run.

No warranty

The content is provided “as is”, without warranty of any kind. To the extent permitted by law, the author is not liable for any loss or damage arising from the use of information or code on this site.

Code samples

Unless a post says otherwise, short code samples and configuration snippets may be reused in your own projects, including commercial ones. Attribution is appreciated and not required.

Text and images

The written content and original images are copyright of the author. You may quote short excerpts with a link back to the original post. Do not republish full posts without permission.

This site may display advertisements and may contain affiliate links. If you buy through an affiliate link, the site may earn a commission at no extra cost to you. Affiliate relationships do not change what is recommended, and posts that contain affiliate links say so.

Links to third-party sites are provided for convenience. The author does not control those sites and is not responsible for their content.

Changes

These terms may be updated. The date at the top of the page shows the latest revision.

Contact

Questions can be sent through the contact page.